Configuring the Camera
Basler IP Camera 23
Click the Motion Mask button to open the Motion Mask Editor as shown below.
The motion mask defines the area(s) of the image that will be used for the camera’s
motion detection function (see Section 3.5 on page 32). Highlighted areas in the
editor will be included in the motion detection mask and used for motion detection.
Unhighlighted areas will not. To highlight an area within the editor, simply left click
your mouse and drag the cursor over the editor screen.
Note that you can set the mask so that it covers a single area as shown above or
so that it covers several different areas within the image.
You can use the All On button at the bottom of the screen to highlight all areas of
the editor and the All Off button to unhighlight all areas. Use the Invert Mask button
to swap the highlighted areas and the unhighlighted areas. Clicking the Load Mask
From Camera button will display the mask settings that are currently saved in the
camera.
Any changes you make using the mask editor will not be saved in the camera until
you click the Save Mask To Camera button. The Close button will close the editor.
To Next Page
Loading...
Need help?
General
