Configuring the Camera
36 Basler IP Camera
3.6.3 Alarm Actions Section
The alarm actions section of the alarm handling parameters is used to control the actions that will
be taken when an alarm condition is declared.
Digital Output Tab
Action Enable - Check the Action Enable box on the Digital Output
tab to enable the camera’s digital output line as an action to take when
an alarm condition is declared. If the digital output line is enabled as
alarm action, it will become active when an alarm condition is
declared.
Digital Output Hold Time - Sets the amount of time (in
milliseconds) that the output line will remain active after an alarm
condition is declared.
Email Tab
Action Enable - Check the Action Enable box on the Email tab to
enable the sending of an email as an action to take when an alarm
condition is declared.
Include Image - Check the Include Image box to include an image
with the email. The included image will be in JPEG format and will be
an image that was captured when the alarm was declared. The image
will be the size of the sensor AOI (see Section 3.4.1 on page 16).
Email - Enter a valid email address for the recipient of the email.
Email Server - Enter a valid address for the SMTP server that will be used to send the email.
Email Port - Enter the port to use on the target email server.
Email User Name - Enter a user name for authentication on the SMTP server. Up to 15 numbers
and/or letters (upper or lower case) can be used.
Email Password - Enter a password for authentication on the SMTP server. Up to 29 characters
can be used. All standard keyboard characters are valid.
To Next Page
Loading...
Need help?
General
