Configuring the Camera
Basler IP Camera 37
HTTP Tab
Action Enable
- Check the Action Enable box on the HTTP tab to
enable the sending of an HTTP request as an action to take when an
alarm condition is declared.
HTTP URL - Enter a valid URL request. You could, for example,
enter this request: http://MyServer/cgi-bin/alarm.cgi
You should be aware that the camera will automatically add the
following two parameters to the end of the request:
?host=<hostname>&date=<date/time>
where the hostname is the camera’s host name and the date/time is
the current date and time.
FTP Tab
Action Enable - Check the Action Enable box on the FTP tab to
enable the sending of an FTP upload as an action to take when an
alarm condition is declared. The upload will be a text file that includes
information such as the camera host name and the date and time.
Include Image - Check the Include Image box to include an image
with the FTP upload. The included image will be a separate JPEG file
and will be an image that was captured when the alarm was declared.
The image will be the size of the sensor AOI (see Section 3.4.1 on
page 16).
FTP Server - Enter a valid address for the FTP server that will receive the upload.
FTP Port - Enter the port to use on the target FTP server.
FTP User Name - Enter a user name for authentication on the FTP server. Up to 15 numbers and/
or letters (upper or lower case) can be used.
FTP Password - Enter a password for authentication on the FTP server. Up to 29 characters can
be used. All standard keyboard characters are valid.
To Next Page
Loading...
Need help?
General
