Page 13<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 63634
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
A(&'+7*#.&&$"83
S(&+7*5 S&##"+7*%T,'#*# G"Z*7>%?&7'$"&8#
Tool will not start. 1. Battery Pack not properly connected.
2. Battery Pack not properly charged.
3. Battery Pack burnt-out.
4. Internal damage or wear. (Carbon
brushes or Trigger, for example.)
1. Remove Battery Pack, make sure there are no
obstructions, reinsert the Battery Pack according
to its shape (it should only fit one way), and press
firmly until the Battery Pack locks in place.
2. Make sure Charger is connected and
operating properly. Give enough time for
Battery Pack to recharge properly.
3. Dispose of old Battery Pack properly or recycle.
Replace Battery Pack.
4. Have technician service tool.
Tool operates slowly. 1. Forcing tool to work too fast.
2. Battery Pack wearing out.
1. Allow tool to work at its own rate.
2. Dispose of old Battery Pack properly or recycle.
Replace Battery Pack.
Performance
decreases over time.
1. Carbon brushes worn or damaged.
2. Blade dull or damaged.
1. Have qualified technician replace brushes.
2. Keep blades sharp. Replace as needed.
Excessive noise
or rattling.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
Have technician service tool.
Overheating. 1. Forcing tool to work too fast.
2. Blade misaligned.
3. Blade dull or damaged.
4. Blocked motor housing vents.
1. Allow tool to work at its own rate.
2. Check and correct blade to fence alignment.
3. Keep blades sharp. Replace as needed.
4. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
% <&77&)%,77%#,2*$>%/(*4,'$"&8#%).*8*Y*(%9",38&#"83%&(%#*(Y"4"83%$.*%$&&71%%%
X"#4&88*4$%W,$$*(>%S,4Z%,89%T.,(3*(%/&)*(%#'//7>%+*2&(*%#*(Y"4*1
To Next Page
Loading...
