Bauer PSS 1.2 - Supplemental Seal

26
Operating Manual for FAN Press Screw Separator 1.2/3.2/3.3/5.2
S
Length X
Required distance
42,5 to 43,5
0mm
43,5 to 44,5
1mm
44,5 to 45,5
2mm
45,5 to 46,5
3mm
etc.
etc.
13.1.2 Supplemental Seal
The supplemental seal provides additional protection for
the attached unit of the geared motor and forms one
stage of the labyrinth seal
Subsequent installation of the supplemental seal:
1. Sand the weld seam until bare.
The diameter of the auger is 125 mm for SFK augers
and 135 mm for LFK augers.
Older augers may have a larger diameter than indi-
cated above. If this is the case, the auger must be
lathed down.
2. The length "X" determines the required spacer ring –
see Fig. 13-5
The following spacer rings are available:
1mm,2mm and 3mm.
If a distance of 3mm is required, install 1mm+
The 2mm spacer ring.
Spacer ring
Sliding ring
O-Rings
Bushing
Ring
Fig. 13-4 Supplemental seal
2.) Measure length X
1.)Sand the weld
seam until bare
1.)Sand the weld
seam until bare
Fig. 13-5 Definition of the spacer ring