29
as connection
ALL INSTALLATION AND SERVICE WORK MUST BE
CARRIED OUT BY A CORGI REGISTERED ENGINEER.
o Prior to installation, ensure that the gas supply conditions
(nature of the gas and gas pressure) and the adjustment
conditions are compatible. The adjustment conditions for this
appliance are stated on the rating plate which can be found on
the back cover.
o This appliance is not designed to be connected to a combustion
product evacuation device. Particular attention should be given
to the relevant requirements regarding ventilation.
o In compliance with the
manufacturer’s installation
instructions, the adaptor elbow
should be connected to the gas inlet
at the rear of he appliance and
pointing in a downward direction. As
indicated in the diagram opposite.
o IMPORTANT: THE FIBRE
E
G
WASHERS SHOWN IN THE ABOV
DIAGRAM MUST BE IN PLACE
WHEN CONNECTING THE
o
o If the cooker has been converted for use with LPG, then it should
m to he length of
hose chosen should be su h itu, the
hose does not touch the floo
o Care should be taken to ens
areas at the rear of the coo
with the flexible hose do no
50°C for LPG.
o IMPORTANT: On comp t
ADAPTOR ELBOW.
Connection to the cooker should be made with an approved
appliance flexible connection to BS 669.
be connected to the gas supply using an appropriate bayonet
type hose. The hose MUST be suitable for use with LPG gas,
these are identifiable by a red band or stripe.
1.25m is recommended. T
c that when the cooker is in s
r.
ure that the temperature rise of
ker that are likely to come in contact
t exceed 70°C for natural gas and
o A hose length of 0.9
le ion carry out a gas tightness test.
To Next Page
Loading...
