31
inimum flow adjustment for hob gas taps.
The correct adjustment is obtained when the flame has a
For butane/propane gas, the adjusting screw must be tightly
f
o Make sure that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then remove
d make further adjustments to the gas
flow, testing it again onc t
o IMPORTANT: On completion carry out a gas tightness
test.
M
All work must be carried out by a CORGI registered
engineer.
o Light the burner and set the knob
at the minimum position.
o Remove the knob from the tap and
place a small bladed screwdriver in
the centre of the tap shaft.
o Unscrew the adjusting screw, in order to increase the gas flow
or tighten the adjusting screw to decrease the gas flow.
o
length of about 3 – 4 mm.
o
screwed in.
o Re it the control knob.
the control knob an
e he adjustment has been made.
To Next Page
Loading...
