Updating the device software protrac®
The device software is automatically updated. The text in the
progress bar changes from Erasing... to Programming... and
finally to Verifying....
When the update process is complete, a message appears
stating that the update was successful.
Click the OK button.
The operating state indicator LED flashes green.
The updated AGP device software is immediately active, the AGP
does not need to be restarted.
Notes:
If there are any other Bluetooth® devices nearby, these may interfere with the update
process. If an error message appears during the update, take any other Bluetooth®
devices out of range and restart the update process.
If the error message Erase fail appears, restart the laptop/PC and start the update
process again.
To Next Page
Loading...
Need help?
General
