EasyManua.ls Logo

Baxi RC 06 - 2.2 Shower Function; 2.3 Temperature Value Modification

Baxi RC 06
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
71.09161.01
en
2.2 SHOWER FUNCTION
The shower function ensures better hot water comfort, e.g. during a shower.
This function enables domestic hot water to be drawn at a lower temperature than the
nominal temperature value.
To set or modify the max. shower function temperature value, refer to section 2.3.
This function can be manually activated in the following way:
r1SFTTPOFPGUIFUXPCVUUPOT
+/- and then the button UPBDUJWBUFUIFGVODUJPO
(the message 4)083 briey appears on the display, followed by the message )844
rQSFTTUIF0, button while the ow temperature and the symbol
áBTIPOUIFEJTQMBZ
rUIFEVSBUJPOPGUIFGVODUJPOJT60 minutes (during this time the symbol
ashes).
At the end of this time the domestic hot water temperature returns to the value of the
previously set operating mode (the symbol
is no longer intermittent on the display).
/PUF To disable the function before the end of the 60 minutes, proceed as follows:
rQSFTTPOFPGUIFUXPCVUUPOT
+/- and then the button
rQSFTTUIF0, button, the display shows the message “)84? “..
2.3 TEMPERATURE VALUES MODIFICATION
BY PRESSING THE
BUTTON
To modify the room temperature values, proceed as follows:
rQSFTTUIF*1 button to enable the 130(3GVODUJPO
rQSFTTUIF
button to select the required function as described in the following table:
'VODUJPO%JTQMBZ%FTDSJQUJPOPGGVODUJPO
$0.'3
The set temperature value ashes
(factory setting = 20°C)
Boiler operation in heating mode at nominal
temperature.
&$0/.
The set temperature value ashes
(factory setting = 18°C)
Boiler operation in heating mode at reduced
temperature.
/0'34
The set temperature value ashes
(factory setting = 5 °C)
Boiler operation in heating mode at room frost
protection temperature.
4)083
The set temperature value ashes
(factory setting = 40°C)
Boiler operation in DHW mode at DHW
temperature set.
r1SFTTUIF+/- button to modify the value of the selected function.
r1SFTTUIF*1 button to exit the function.

Related product manuals