40
71.09161.01
en
3
.
ERROR MESSAGES AND TABLE OF FAULTS
BLOCK
If a block occurs, the display shows the
symbols ashing toge-
ther with the &3303 writing alternated, with 2 seconds step, with the
0, ashing writing.
The block fault is identied by an error code (see the table below) followed
by & letter.
0605_3101
Press the 0, button (gure 1) to reset the gas boiler. The display shows the
3&4&5 writing and then the 0,writing
There are two type of fault carried out
by the temperature control: FAULT and
BLOCK.
FAULT
If a fault occurs, the display shows the
symbols ashing together with the
&3303 writing.
0606_2207
The fault is identied by an error code followed by & letter and is not resettable.
Call an authorized Service Centre.
0608_2805
To Next Page
Loading...
Need help?
General
