Baxi RC 06 - 4. Parameters Display; 4.1 Info & Advanced Settings

42
71.09161.01
en
4.
PARAMETERS DISPLAY
To access the Information and Advanced Setting mode, it is necessary to press, for at
least 3 seconds, the *1CVUUPOJO*/'0NPEFUIFEJTQMBZTIPXTi*/'0w.
To escape the INFO mode briey press the *1 button. In this mode press the 0,
CVUUPOUPTDSPMMUIFXJOEPXTUPTFUQBSBNFUFSTQSFTTUIF+/-
button.
8"3/*/(
Communications between the main board and the remote control is not imme-
diately. In some case it may happen that the command given through the remote
control takes some time depending on the type of the transferred information.
$&/53"-)&"5*/($)
ri$)4-w Max. heating circuit setpoint, value settable with the buttons +/-
.
8"3/*/(to change the unit of measure from °C to °F and
vice versa, press the
button.
ri&95¡Dw Outside temperature (with external sensor connected).
ri$)0w Maximum Heating ow temperature.
ri$)3w Return heating temperature (unplanned).
ri$)4?w CH temperature setpoint.
ri$).9w Maximum CH temperature setpoint (max. settable value).
ri$)./w Minimum CH temperature setpoint (min. settable value).
4.1 INFORMATION AND ADVANCED SETTING MODE