6. OPERAtION
INITIAL START-UP
Warm-up time of 15 minutes stabilizes the measured values after switching on.
6-1. BASIC OPERAtION
6-1-1. POWER ON/Off
Switch on the balance by pressing power On/ Off key. The display is switched on and the test is started and if
want to switched off, press backward the key.
6-1-2. zERO
Environmental conditions can lead to the balance exactly zero in spite of the platform not taking any strain.
However, you can set the display of your balance to zero any time by pressing key and therefore ensure
that the weighing starts at zero.
6-1-3. tARE
The weight of any container can be tared by pressing button so that with subsequent weighing the net
weight of the object being weighed is always displayed.
Load weight on the platform >
Press >
key. Zero is displayed, and tare is subtracted.
Remove weight on the platform. Tared weight is displayed. It can set only one tare value. It will be shown >
with a minus value.
Press G/N to change between gross weight and net weight >
To clear the tare value, remove the load and press > . key. Zero is displayed, tare weight is cleared.
6-1-4. UNIt PRICE SEttINg
Place the goods on the platform
Enter the unit price by pressing numeric keys.
For e.g.: 50.00
Unit price display will be shown the entered value and total price display will be shown price of the go- >
ods.
Press > key to replace the previous unit price.
KEyPAd dESCRIPtION
KEYS DESCRIPTION KEYS DESCRIPTION
Set the display to zero.
to
Vender keys.
Enter the clear tare weights, Storing the current
weight as tare value. Subtracting the tare value
from the total weight and displays the result as
net weight.
to
To select direct PLU, press and hold 3 seconds
these keys to recall PLU information.
To print the previous data. To enter the PLU numbers.
Look up the accumulated price of the each vendor
keys.
To recall the PLU 29 to 56 by pressing 1 to 28.
To enter into the function settings. Clear incorrect entries and error conditions.
KEyS IN tHE PARAmEtER SEttINgS
KEYS DESCRIPTION KEYS DESCRIPTION
To enter into the function and parameter set-
tings.
Scroll down to the sub parameters.
&
Scroll to function or parameter.
Escape from the parameter settings and return to
the normal weighing mode.
dISPLAy dESCRIPtION
DISPLAY WEIGHT DESCRIPTION DISPLAY UNIT PRICE DESCRIPTION
ZERO Zero display
V1/V2/V3 Vendor keysSTABLE Stability Display
NET Net Weight
DISPLAY TARE DESCRIPTION DISPLAY TOTAL PRICE DESCRIPTION
STOCK Stock mode CHANGE Change mode
REMOTE
Remote Scale BATT. Battery
To Next Page
Loading...
Need help?
General
