6. OPERAtION
INITIAL START-UP
Warm-up time of 15 minutes stabilizes the measured values after switching on.
6-1. BASIC OPERAtION
6-1-1. POWER ON/Off
Switch on the balance by pressing power On/ Off key. The display is switched on and the test is started and if
want to switched off, press backward the key.
6-1-2. zERO
Environmental conditions can lead to the balance exactly zero in spite of the platform not taking any strain.
However, you can set the display of your balance to zero any time by pressing
key and therefore ensure
that the weighing starts at zero.
6-1-3. tARE
The weight of any container can be tared by pressing
button so that with subsequent weighing the net
weight of the object being weighed is always displayed.
Load weight on the platform >
Press >
key. Zero is displayed, and tare is subtracted.
Remove weight on the platform. Tared weight is displayed. It can set only one tare value. It will be shown >
with a minus value.
Press G/N to change between gross weight and net weight >
To clear the tare value, remove the load and press >
. key. Zero is displayed, tare weight is cleared.
6-1-4. UNIt PRICE SEttINg
Place the goods on the platform
Enter the unit price by pressing numeric keys.
For e.g.: 50.00
Unit price display will be shown the entered value and total price display will be shown price of the go- >
ods.
Press >
key to replace the previous unit price.
To Next Page
Loading...
