Chapter 6: Plumbing 245
•
Owner’s Manual
Supplement
40
Marine Head with Holding Tank (If Equipped)
• Before using this system, read the
marine head operation and mainte-
nance manual.
• Look at the side of the holding
tank to check the content level.
• The holding tank is plumbed to a
waste fitting on the deck for dock-
side pump-out.
• Empty the holding tank at every
opportunity.
Using The Marine Head
1. Open the head’s seawater intake seacock.
2. Before using the head, pump water into the bowl to wet the sides.
3. After use, pump until the bowl is clean.
4. Pump a few more times to clean the lines.
5. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.
• Close the intake seacock while the boat is underway or when the system will not be used for long periods of time.
Winterizing The Marine Head
Read the marine head operation and maintenance manual for winterizing instructions.
Check with local authorities for regulations regarding the legal use of marine head systems.
NOTICE
HEADSEAWATER INTAKE
SEACOCK
WASTE PUMP-OUT
DECK FITTING
HOLDING TANK
VENT
HOLDING TANK
To Next Page