BCI Advisor - Invasive Blood Pressure Warnings, Cautions, and Notes; Temperature Warnings, Cautions, and Notes

To Next Page

To Previous Page

Chapter 1: Introduction

Advisor

Service Manual 1-11

Invasive Blood Pressure Warnings, Cautions, and Notes

WARNING! Avoid conductive connection with any metal parts.

NOTE! The IBP ZERO NEEDED message is displayed when the monitor is turned on, when the site label

is changed, or when the transducer is connected to the monitor (even if the same transducer is

disconnected then reconnected to the monitor).

NOTE! Use only invasive pressure transducers and interface cables specically intended for use with this

device and its side panel connectors.

NOTE! The IBP1 and IBP2 waveforms must be visible and adjacent in order to be overlaid.

NOTE! When IBP1 and IBP2 are overlaid, the scale settings for IBP1 and IBP2 are changed to the higher of

the two scales.

NOTE! Dual channel simulators may aect verication of IBP operation. Use only single channel

simulators.

NOTE! All specied transducers were tested for immunity to radiated radio frequency electromagnetic

elds at a level of 3V/m in accordance with IEC 60601-2-34:2000. Additional validation at levels

of 10V/m was performed using the pvb Critical Care GmbH xtrans

and Edwards Lifesciences

TruWave transducers.

Temperature Warnings, Cautions, and Notes

NOTE! Use only temperature sensors and interface cables specically intended for use with this device.