Bdcom S2510-B User Manual

S2510-B Hardware Installation Manual
- 14 -
Chapter 4 S2510-B Maintenance
Caution:
1) Before opening the chassis, make sure that you have released the static you
carried and then turn off the power on-off of S2510-B. Before operating any step
in Appendix B, read the section “Safety Advice”.
2) Before performing operations beside the power supply or on the chassis, turn off
the power on-off and plug out the power cable.
4.1 Opening the Chassis
This section describes how to open the chassis of the switch, required tools and
operation methods.
Caution:
When the power cable still connects the power supply, do not touch it.
When you open the chassis of the switch, you may use the following tools: These tools
are:

Crossed screwdriver

Static armguard
Perform the following steps to open the chassis of the switch:
1) Cut off the power of the switch;
2) Plug off all cables that connect the ports of S2510-B;
3) Take out the bolt from the chassis with the screwdriver;
Note:
The chassis comprises of two parts: chassis and bottom. Open the chassis by holding
two sides of the chassis towards the direction of the arrow key shown in the following
figure;
Figure 4-1 Opening the chassis of S2510-B

Bdcom S2510-B Specifications

General

Brand	Bdcom
Model	S2510-B
Category	Switch
Language	English