Bdcom S2510-B User Manual

S2510-B Hardware Installation Manual
- 7 -
2.3.4 Power Requirements
You must check the power supply and make sure the good grounding of the power
supply system. Then you must pay attention to the range of input power, which is
proper when the input power ranges from 36 to 72 VDC.
Caution:
If the power supply system does not have good grounding, or the input power disturbs
too much and excessive pulses exist, the error code rate of communication devices
increases and even the hardware system will be damaged.
2.4 Installation Tools and Device
The tools and devices to install the S2510-B are not provided by the S2510-B. You
yourself need to prepare them. The following are the tools and devices needed for the
typical installation of the S2510-B switch:

Screwdriver

Static armguard

Bolt

Ethernet cable

Other Ethernet terminal devices

Control terminal

Bdcom S2510-B Specifications

General

Brand	Bdcom
Model	S2510-B
Category	Switch
Language	English