S2928F Hardware Installation Manual
- 8 -
The clapboard separates exhaust gas and inflow air, and boost the cool air to flow in
the chassis. The best location of the clapboard is decided by the air flow mode in
the chassis, which can be obtained through different location tests.
2.3.4 Power Requirements
Make sure that the power supply has nice grounding and the power at the input side of
the switch is reliable. The voltage control can be installed if necessary. At least a 240 V,
10A fuse or a breaker is provided in the phase line if you prepare the short-circuit
prevention measures for a building.
Caution:
If the power supply system does not have good grounding, or the input power disturbs
too much and excessive pulses exist, the error code rate of communication devices
increases and even the hardware system will be damaged.
2.4 Installation Tools and Device
The tools and devices to install the S2928F switch are not provided by the S2928F
switch. You yourself need to prepare them. The following are the tools and devices
needed for the typical installation of the S2928F switch:
Other Ethernet terminal devices