What to do if BDS Drill motor doesn't start or stops?
If the BDS Drill motor doesn't start or stops during operation, there might be a few reasons. First, check if the plug is properly inserted into the socket and insert it if it is not. Second, ensure that the circuit breaker is switched on. Finally, verify that the magnetic clamp is also switched on.
Why is the magnetic clamp not working on my BDS Drill?
If the magnetic clamp on your BDS Drill isn't functioning, it could be due to a couple of reasons. First, make sure the magnet is switched on. If it is, check whether the surface you're working on is magnetic. If not, use a suitable magnetic base.
What to do if the circuit breaker trips when using my BDS MABasic 200?
If the circuit breaker trips when using your BDS Drill, it might be because too many appliances are connected to the same power circuit. Try reducing the number of appliances on the power circuit. If the problem persists, the machine may be defective.
Defines the machine's specific purpose and prohibits improper use.
Lists essential precautions for safe operation, covering electrical and general safety.
Details critical steps to prevent electric shock during machine operation.
Outlines measures to avoid injuries from improper handling or operation.
Step-by-step instructions and safety warnings for inserting drill bits.
Procedures for safely activating and deactivating the magnetic clamp.
How to switch the machine's motor on and off using the designated switch.
Procedures for safely resolving blockages caused by broken tools or swarf.
Steps to take for other types of blockages encountered during operation.
A table listing common machine faults, their possible causes, and solutions.
To Next Page
General
