Beastx Aircraft - Microbeast Overview

82
MICROBEAST OvERvIEW
SETUP MENU
(Menu LED is steady ON )
Status-LED:
o purple red ashing red blue ashing blue
A
Mounting orientation upright (vertical) at (horizontal)*
B
Swashplate servo - frequency user dened 50 Hz* 65 Hz 120 Hz 165 Hz 200 Hz
C
Tail servo - center position pulse length user dened 960 μs 760 μs 1520 μs*
D
Tail servo - frequency user dened 50 Hz* 165 Hz 270 Hz 333 Hz 560 Hz
E
Tail servo - rotor endpoints tail stick - move to right endpoint and wait / left endpoint and wait
F
Tail - sensor direction normal* reversed
G
Swashplate - servo centering reference position CH1 center pos. CH2 center pos. CH3 center pos.
H
Swashplate - mixer user dened mechanical 90° 120°* 140° 140° (1=1)
I
Swashplate - servo directions nor | rev | rev nor | nor | rev* nor | rev | nor nor | nor | nor
J
Swashplate - cyclic pitch geometry aileron stick – adjust 6° cyclic pitch on the roll axis (blades aligned with fuselage)
K
Collective pitch range collective stick on max and min position and use tail stick to adjust desired pitch
L
Swashplate - cyclic limit move aileron, elevator and pitch sticks – adjust max limits with tail stick
M
Swashplate - sensor directions rev | rev rev | nor nor | rev nor | nor*
N
Pirouette optimization direction normal* reversed
Status-LED:
o purple red ashing red blue ashing blue
A Swashplate - cyclic center adjustment aileron and elevator stick – reset with tail stick
B Control behavior user dened normal sport* pro extreme transmitter
C Swashplate - pitching up behavior user dened very low low medium* high very high
D Tail - HeadingLock gain user dened very low low medium* high very high
E Stick deadband user dened 1 2* 3 4 5
F Tail - torque precompensation (RevoMIX) user dened o* low - nor high - nor low - rev high - rev
G Cyclic response user dened normal* slightly increased increased high very high
H Pitch boost user dened o* low medium high very high
* Factory setttings
PARAMETER MENU
(Menu LED is ashing quickly)