Beastx Aircraft - Adjustment Options - Overview

83
ADjUSTMENT OpTIONS - OvERvIEW
Never y while the MICROBEAST is in one of the setup or parameter menu!
In this condition the gyro control and the stick controls are disabled.
operational
parameter menu
point A
operational
. . .
Push button
shortly
operational
setup menu
point A
setup menu
point N
operational
. . .
Hold button a
long time
powered o
receiver menu
point A
END of
adjustment
. . .
Hold button
pushed
receiver menu
point N
Push button
shortly
Push button
shortly
when selecting „standard“ at point A
Push button
shortly
receiver menu:
parameter menu:
setup menu:
and
power on while still
pushing the button
Push button
shortly
Push button
shortly
parameter menu
point H
Status-LED:
Tail gyro mode:
o, ashing blue or blue
= HeadingLock mode
purple = Normal-Rate mode
Menu LEDs: Amount of tail gain A=0% to N=100%
(only after powering up or when adjusting the gain)
Button:
- to enter setup menu push down several
seconds until LED A is steady on
- to enter Parameters menu push shortly
until LED A is ashing
Dial 1: cyclic gain
Dial 2: direct cyclic feed forward
Dial 3: tail dynamic