To Next PageTo Next Page
Need help?Do you have a question about the Beck IPC@CHIP SC01 and is the answer not in the manual?
General| Clock Speed | 200 MHz |
|---|---|
| RAM | 32 KB |
| Power Supply | 3.3V |
| Operating Voltage | 3.3V |
| Ethernet | 10/100 Mbit |
| Serial Ports | 2 |
| Operating Temperature | -40°C ... +85°C |
| Communication Interfaces | Ethernet, UART, I2C, SPI |
Details interrupt request pins (INT) and interrupt acknowledge (INTA#).
Explains pins for the 10Base-T Ethernet interface, including TP drivers and receivers.
Describes pins for serial communication (TxD, RxD, CTS, ENRX0, RTS, RTR0) for serial ports.
Details the RESET# and NMI pins, including power fail monitoring.
Illustrates the memory organization for SC01/SC02 and SC11/SC12, including Flash, ROM, and RAM.
Defines the limits for storage, supply voltage, current, and pin voltage.
Lists electrical DC characteristics for various voltage and current parameters.
Circuit example for 16C452/552 UART with FIFO and printer port interface.
Circuit demonstrating an Ethernet to Ethernet router configuration using two IPC@CHIP SC12 units.
