Becker AR6201 - Page 55

AR6201 - RT6201 - RCU6201 - AR6203
DV 14307.03 Issue 1 09/2013 Page 2-23
Display Contents Description
MDE PAGES
STANDBY FREQUENCY
BATTERY VOLTAGE
CHANNEL MEMORY
On “MDE PAGES” page
three options are selectable
by means of the “ROTARY ENCODER”. The t
hree
frequency selection modes provide
different user
interfaces for operating frequency
selection.
Enabling/Disabling can be toggled by pushing the
“STO” button.
STANDBY FREQUENCY
enables/disables “Standard Mode”
BATTERY VOLTAGE
enables/disables “Direct Tune
Mode”.
CHANNEL MEMORY
enables/disables “Channel Mode”.
After deselecting “BATTERY VOLTAGE” the “DIRECT
TUNE MODE” page is no longer available in the
normal operation.
Storing a frequency in a specific channel will be
possible even if only “BATTERY VOLTAGE” or
“STANDBY FREQUENCY” remain selected.
At least one page will remain active, deselecting
all options from the “MDE PAGES” is not possible
Note: Menu available on AR620X and RCU6201
On “LOW BATT THR” page
the threshold for
indication of the “LOW BATT” warning page can b
e
adjusted (default setting is 10.5 V). The l
ow
battery threshold depends on battery type in use
and should be adjusted
within 10V…33V by the
installer turning the “ROTARY ENCODER”. “LOW BATT”
warning page is
displayed if the supply voltage
drops below the “LOW BATT THR” value.
Recommended vales:
“LOW BATT THR” = 11V for 12V battery
“LOW BATT THR” = 24V for 24V battery
Note: Menu available on primary and secondary
controller
Options 1 to 4
On “CONFIGURATION
” page 6 or 7 options can be
selected. (refer to the note under
AUX AUTO MUTE
in
the column on the right side) Use the “ROTARY
ENCODER” to scroll up and down, then and push the
“STO” button for selection.
TANDEM
- if selected, a second controller RC
U6201
can be connected to AR620X/RT6201.
AUX INPUT - if selected, the auxiliary audio signal