161
Radio mode
Selecting automatic tracking
In all modes and wavebands, automatic
tracking can be turned on by pressing
and holding the button for more than
2 seconds.
In the TP menu:
X Press multifunction button re-
peatedly until TP on appears.
Selecting / cancelling direct
programming
X Switching on TP menu.
Selecting:
X Press the multifunction button.
X Using the right rotary control , se-
lect the desired TP station and press to
confirm.
After a short delay and without actua-
tion, the selected station is accepted.
Cancelling:
X Press the multifunction button.
X Select Autoselect with the right rotary
control and press the control to
confirm.
After a short delay and without actua-
tion, direct programming is cancelled.
Switching mute on/off
X After selection of a TP or EON sta-
tion, the mute function can be activat-
ed by pressing the button briefly.
Thereafter, only traffic announcements
and navigation announcements will be
switched through.
X The mute function is cancelled by
pressing the button again.
Interrupting TP announce-
ments
An announcement currently being
broadcast can be interrupted.
X Briefly press the button during the
TP announcement.
The unit switches back to the previously
selected mode.
Attention:
If a TP station has already been pro-
grammed directly, it will once again be
selected as the TP station.
To Next Page
Loading...
