To Next Page

To Previous Page

15 | VT 4.10, VT 4.16, VT 4.25, VT 4.40, VX 4.10, VX 4.16, VX 4.25, VX 4.40

4.5 MOTORS

The characteristics of the motor used can be found on the motor's type plate.

4.6 SAFETY AND PROTECTIVE DEVICES

DANGER

Danger to life due to defective, dismantled and manipulated protective devices

NOTE

For a description of the safety instructions, see chapter 2.9

The protective devices of the pump must not be dismantled, modified or put out of operation. If the protective

devices are dismantled, modified or put out of operation, the pump must be shut down and secured immediately.

Defects in protective equipment must be rectified immediately. All protective equipment must be undamaged, fully

assembled and in working order. Warning and information signs must be clearly visible.

All protective devices must be checked for functionality, damage and completeness after each maintenance of the

pump.

If a maintenance activity requires the dismantling of protective devices, these may only be dismantled for the

duration of the maintenance activity. All protective devices must be completely mounted in the designated place

immediately after completion of the maintenance activities and checked for proper functioning.

The prescribed inspection intervals for protective devices must be observed and complied with. Protective devices

may only be maintained, replaced and serviced by specially trained, instructed and authorised personnel.

Unauthorised tampering and manipulation with the safety-related parts of the pump are strictly prohibited and must

be reported immediately to the responsible body.

All equipment serving safety and accident prevention, such as warning and information signs, covers, protective

coverings, etc., must be in place. The removal or alteration of these facilities is prohibited. Damaged facilities must be

repaired immediately.

Below is an overview of the pump with the designations of the protective devices.

VT 4.10, VT 4.16, VT 4.25, VT 4.40, VX 4.10, VX 4.16, VX 4.25, VX 4.40

Position

Component

Location

Device cover

Back cover

Table 4.6: Safety and protective devices 1

4.7 TESTING THE SAFETY AND PROTECTIVE DEVICES

NOTE

All safety and protective devices must be checked regularly according to chapter 8.3.

The condition and function of safety and protective devices must be checked when:

• Modifications and repairs have been made to the pump

• Damage has occurred to the pump

• maintenance and servicing intervals are to be carried out.

Becker VX 4.25 User Manual

Other manuals for Becker VX 4.25