Fitting and wiring
BC9000 and BC9100 19Version: 4.0.0
3.2.3 Ethernet connection
The connection to Ethernet is made via an RJ45 connector (a Western plug).
Fig.7: RJ45 connector (Western plug)
Cabling
Connection via hub or switch
Fig.8: Ethernet connection via hub or switch
Connect the PC's network card to the hub/switch using a standard Ethernet cable, and connect the hub,
again using a standard Ethernet cable, to the Bus Terminal controller. Connection via a switch is done in the
same way.
Direct connection between PC with Ethernet card and BC9000
Fig.9: Direct Ethernet connection (crossover cable)
Use a crossover Ethernet cable to connect the PC directly with the Bus Terminal Controller.
Pin assignment of the RJ45 plug
PIN Signal Description
1 TD + Transmit +
2 TD - Transmit -
3 RD + Receive +
4 - reserved
5 - reserved
6 RD - Receive -
7 - reserved
8 - reserved
To Next Page
Loading...
