What to do if the rotor load is severely out of balance in Beckman Coulter Laboratory Equipment?
If the rotor load is severely out of balance in your Beckman Coulter Laboratory Equipment, ensure that tubes or bottles are loaded symmetrically in the rotor. For swinging bucket rotors, lubricate the buckets according to the rotor manual instructions.
What to do if the door of Beckman Coulter Avanti J-26S XPI will not open at the end of a run?
If the door of your Beckman Coulter Laboratory Equipment will not open at the end of a run, especially after low-temperature runs (near –10°C) when ice forms around the door opening, press firmly in several locations around the door opening, then depress the foot pedal again. To minimize icing, wipe moisture from the chamber, the chamber gasket, and the inner door surface before each run.
What to do if the door of Beckman Coulter Laboratory Equipment is not closing?
If the door of your Beckman Coulter Laboratory Equipment is not closed firmly enough, or debris in the latch area may be preventing latches from closing securely, reclose the door firmly, placing your hand over the drawing of the hand on the door label. Gently clean the latch areas with a dry, lintless cloth. If L2 continues to appear after cleaning, call Beckman Coulter Field Service.
What to do if the foot pedal was depressed before end of run in Beckman Coulter Avanti J-26S XPI Laboratory Equipment?
If the foot pedal was depressed before the end of run in your Beckman Coulter Laboratory Equipment, press CE and try to restart the run. If this does not work, call Beckman Coulter Field Service.
What to do if there is a momentary power failure and the rotor does not come to a complete stop in Beckman Coulter Laboratory Equipment?
If your Beckman Coulter Laboratory Equipment experiences a momentary power failure and the rotor does not come to a complete stop, press CE to clear the message or call your Beckman Coulter Field Service representative.
What to do if there is a power failure and rotor comes to a complete stop in Beckman Coulter Laboratory Equipment?
If your Beckman Coulter Laboratory Equipment experiences a power failure and the rotor comes to a complete stop, press CE to clear the message.
What to do if the door stays locked after rotor stops spinning in Beckman Coulter Avanti J-26S XPI?
If the door of your Beckman Coulter Laboratory Equipment stays locked after the rotor stops spinning, restart the centrifuge and perform a brief run. If the door still will not open after deceleration, call Beckman Coulter Field Service.
What to do if the FRS level is too high in Beckman Coulter Avanti J-26S XPI Laboratory Equipment?
If your Beckman Coulter Laboratory Equipment shows the message F2, press CE. If the F2 message reappears, perform the same actions as for the Fl error.
What to do if the required FRS level is not reached in Beckman Coulter Avanti J-26S XPI?
If the required FRS level is not reached in your Beckman Coulter Laboratory Equipment, check and clean the door sealing area and door gasket. Wipe any ice and excess moisture from the chamber.
What to do in case of misidentification of the JCF-Z rotor in Beckman Coulter Avanti J-26S XPI Laboratory Equipment?
If you are experiencing misidentification of the JCF-Z rotor with your Beckman Coulter Laboratory Equipment, call your local Beckman Coulter Field Service representative for more information.
General| Brand | Beckman Coulter |
|---|---|
| Model | Avanti J-26S XPI |
| Category | Laboratory Equipment |
| Language | English |
To Next Page