Bego Nautilus T - Wireless Network Setup; WLAN Connection Procedure and Settings

English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
21
86105 BA-en/00
en
6. If DHCP is not supported by your network, use
the expert mode "Static". Contact an IT spe-
cialist, if needed.
Network connection via WLAN
1. Switch the device off.
2. Insert the WLAN USB adapter on the back of
the device.
3. Switch the device on. The BEGO software will
be loaded.
4. Go to "Settings" > "System" > "Internet".
5. Press the WLAN button (see illustration).
6. Select the WLAN network.
If the WLAN network is invisible, select SSID
and the encryption type (WEP, WPA2, etc.).