Bego Nautilus T - Custom Program Creation for Alloys; Alloy Selection and Finder Tool Usage

32
86105 BA-en/00
English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
en
4. Select the alloy with the previously determined
values (see paragraph "Alloy selection" on
page 41).
or
5. Select an alloy my means of the alloy finder
(see illustration).
• The "alloy finder" button calls up a compari-
son table to assist you with determining a
comparable alloy. First, select the melting
interval specified by the manufacturer of the
non-BEGO alloy.
• Then select the alloy group based on the
basic components.
• Select the use of the graphite insert if
required for the casting process.
• Press the "Enter" button first, then confirm
by pressing "OK". A comparable alloy will be
suggested.
An entry mask will appear on the screen where
the data of the new non-BEGO alloy can be
edited.
6. Enter the desired name and the casting tem-
perature. The comparable alloy may be modi-
fied, if needed.
7. Press the "Save" button to set up the alloy pro-
gram.
The newly set up alloy program is now availa-
ble as a favourite in the alloy selection list (see
page 41).