58
86105 BA-en/00
English ⋅ Nautilus
®
CC plus
11. The additional heating time for melting (see the
table on page 35) will be shown on the screen.
12. The timer for the additional heating time can be
customized for a specific program (see page
47). The timer counts down the entered sec-
onds and thus determines the time to cast.
13. Once the timer has run down and the alloys
melt visually appears to be ready for casting,
press the "Casting" button to trigger the casting
process.
The casting is carried out with overpressure.
Alloy, chamber pressure, and casting number
will be displayed during that process.
14. Remove the mould.
15. Close the mould door. The casting process is
completed.
Never look into the melt without
protective glass and protective
eyewear!
The temperature cannot be
measured and thus not be limited
without the pyrometer!
Stay with the device and finish the
preheating and melting as described
manually!
Risk of burns!
Use mould tongs!
To Next Page
Loading...
Need help?
General
