English ⋅ Nautilus
®
CC plus
57
86105 BA-en/00
The chamber is evacuated during preheating.
The preheating may last for up to 60 seconds.
8. Have the mould readily available before press-
ing the "OK" button to prevent the alloy from
cooling down unnecessarily. Preheating tem-
perature and vacuum are maintained until
then.
9. Close the mould door.
The next display is shown when the mould
door is closed.
10. Confirm the melting process with "OK".
In fast mode, the next step will be triggered
immediately upon closing the mould door.
The process can be aborted by pressing the
"Abort" button.
The temperature cannot be
measured and thus not be limited
without the pyrometer!
Stay with the device and finish the
preheating and melting as described
manually!
Risk of burns!
Use mould tongs!
Never look into the melt without
protective glass and protective
eyewear!
To Next Page
Loading...
Need help?
General
