Bego Nautilus T User Manual

78
86105 BA-en/00
English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
en
Updating the software/firmware
Automatic firmware update: The NAUTILUS
®
-
devices automatically update the device software to
the latest firmware version via my.BEGO.com. Upon
every restart of the device, the system checks if new
firmware versions are available and can be
installed.
Do not switch the device off while an update is being
installed!
The device will restart after an update has been
installed.
Firmware update from USB flash drive: The
currently installed software version can be seen in
"Settings" > "Information" (see page 36).
1. Download the latest software version to a USB
flash drive from my.BEGO.com.
2. Insert the USB flash drive into the device.
3. Start the update.
Do not switch the device off while an update is
being installed!
The device will restart after an update has
been installed.
Exporting casting logs via a USB flash drive
The NAUTILUS
®
-device can generate casting logs.
Saving casting logs must be activated in "Settings"
(see page 38).
1. Insert the USB flash drive into the rear side of
the device.
2. Press the "Export" button to download the log
to the USB flash drive.
For diagnostic purposes, the data stored in the
device for the last 10 casts can be copied to the
connected USB flash drive. After connecting the
USB flash drive to the PC, this data can be trans-
mitted to the BEGO Service.
NOTICE
Any casting logs that have been previously stored
on the USB flash drive will be overwritten during
this process. They should be copied to the PC
befo
rehand, if needed.

Bego Nautilus T Specifications

General

Brand	Bego
Model	Nautilus T
Category	Dental equipment
Language	English