10
SHARK DSP110
Fig 1.3: Rear panel control elements and connectors of the DSP110
14
This is the SHARKs balanced XLR output.
15
This is the SHARKs balanced XLR input.
16
The MIC GAIN control adjust the input signal gain, when the INPUT LEVEL
switch
has been pressed (position: MIC). To adjust microphone levels you
can use the CLIP LEVEL indicator, by setting the CLIP LEVEL control to mid-
travel position. Please make sure that the CLIP LED will not light up.
17
Use the POWER SUPPLY CONNECTOR to hook up the SHARKs external
power supply.
18
This is the SHARKs balanced JACK output, which carries the same signal as
the XLR output.
19
The OUTPUT LEVEL switch controls the reference level provided by the outputs
of the DSP110. Possible values are: +4 dBu or microphone level.
1. INTRODUCTION
DATA-MANFULL_DSP110_ENG_Rev. E.p65 20.04.01, 15:4510
To Next Page
Loading...
Need help?
General
