Behringer SHARK DSP110 - Installation of the DSP110 on the Available Rackmount

24
SHARK DSP110
Fig. 5.1: Installation of the DSP110 on the available rackmount (optional)
+ Please, only use the supplied screws to install the SHARKs on the
rackmount. Longer or thicker screws can damage the electronics inside
of the device and doing so will void your warranty rights.
You will need 2 units of space for the DSP110 rackmount. For technical reasons a little
gap remains above the rackmount.
5. RACKMOUNT (OPTIONAL)
DATA-MANFULL_DSP110_ENG_Rev. E.p65 20.04.01, 15:4524