Behringer SHARK DSP110 - SHARK on Single Channels and Subgroups

15
SHARK DSP110
Fig. 2.4: Two SHARKs in the monitor path
2.1.5 The SHARK used in single channels and subgroups
Whenever you want to make sure that wanted feedback such as the feedback sounds
produced by a guitar wont be removed, you should insert one or several DSP110 into
feedback-prone single channels (e.g. vocals) or subgroups of your mixing console!
Route all channels that are susceptible to feedback (e.g. all vocal mics) to one or
several subgroups, in which you insert one or several SHARKs. In this way, all channels
that are less liable to produce feedback (e.g. those carrying line-level signals, or
instrumental microphones with lower volumes) can pass the console unaltered, while
only critical microphone channels are controlled by the DSP110. Thus, you can protect
your sound reinforcement system against feedback and still use wanted feedback
sounds.
2. APPLICATIONS
DATA-MANFULL_DSP110_ENG_Rev. E.p65 20.04.01, 15:4515