Behringer SHARK DSP110 User Manual

5
SHARK DSP110
Be sure that there is enough air space around the unit for cooling and please do not
place the SHARK on high-temperature devices such as power amps, etc. to avoid
overheating.
Please use the enclosed power supply to connect the unit to the mains. The supply
complies with all applicable safety standards.
+ Please note that all units must be grounded properly. For your own safety,
you should never remove any ground connectors from electrical devices
or power cords or render them inoperative.
Further information can be found in chapter 3 INSTALLATION.
As a standard the audio inputs and outputs of the BEHRINGER SHARK DSP110 are
fully balanced. If possible, connect the unit to other devices in a balanced configuration
to allow for maximum interference immunity. The automatic servo function detects
unbalanced connections and compensates the level difference automatically (6dB
correction).
1. INTRODUCTION
DATA-MANFULL_DSP110_ENG_Rev. E.p65 20.04.01, 15:455

Behringer SHARK DSP110 Specifications

General

Brand	Behringer
Model	SHARK DSP110
Category	Recording Equipment
Language	English