Beko DVG593 - Preparation and Burning off; Operating the Hob; Minute Minder

operating the hob
MAIN OVEN TOP OVEN-GRILL
preparation and burning off
Sail
A Important for asthmatic sufferers
i
10
Before using for the first time, protective
coatings need to be burnt off. Fumes will be
emitted but this is quite normal.
Ensure the room is very well ventilated
during the burning off process. Avoid directly
inhaling the fumes during this process.
DOUBLE OVEN
Grill
Open the grill door. Remove grill tray, wire
rack and detachable handle and operate the
grill for about 15 minutes.
Minute Top burners control knob Main oven Lamp Grill Ignition
minder knob button knob button
Turning on and off Flame control
Oven The burner control knobs have a safety feature. e When turning on a hotplate burner, stay
Remove baking tray and shelf racks and 1 Push the appropriate knob in slightly and and make sure that it has lit, and adjust the
operate the oven at gas mark 8 for 30 minutes. turn anti-clockwise to the required setting. flame immediately .
© Selection of the correct flame height is
Cleaning 2 Press the ignition button. especially important to safety. Adjust the
Before you start using your cooker, clean 3 To switch a burner off turn burner flame so that it does not extend
the appliance as recommended under Care the corresponding knob to @. beyond the bottom of the pan, any higher
and cleaning on page 18. e Turning the control knob fully and the flame becomes inefficient and can
clockwise to the small flame symbol enables be a potential fire hazard.
The
shelf
rack
with
a
heat
elses
sheet
you
to
simmer
without
accidentally
switching
e
To
make
sure
that
the
cooker
is
operating
should
be
positioned
in
the
lower
shelf
position
off.
safely,
periodic
checks
are
advised.
in
the
main
oven.
et
e
At
low
settings,
do
not
leave
the
burners
Ignition
button
unattended
for
long
periods
of
time.
e
Pressing
this
button
provides
a
spark
at
all
e
The
burner
flames
should
burn
with
a
visible
Oven burner heat shield positioning
Before you start using your cooker please ensure
he main oven burner heatshield is positioned
as shown.
X
burners, only the one turned on will light.
e If an appliance burner doesn’t light, press
again until it does.
After you release the knob, if the ignition does
not continue repeat the same process by
keeping the knob pressed for 15 seconds. If
still no ignition occurs, wait for 1 minute and
repeat again.
Warning: Do not keep the knob pressed
bluish cone within the main flame, and with
no sign of yellowness. If at the first lighting
they are very noisy and yellow, turn out at
once and check that the burner cap has
been correctly replaced. If on re-lighting
there is no improvement, ask your supplier
to check them. The inner portions of the
flames as described above may not be very
clear, but this is not detrimental in anyway.
in position more than 15 seconds.
The pan supports are not interchangable.
Oven
heatshield
operating
the
minute
minder
o Q
j The mechanical timer is adjustable up to 120 2- Turn the knob anti-clockwise to the desired
minutes. time.
a : oret Bania To obtain 120 timer setting turn the knob 3- At the end of the preset time a buzzer sounds
locat the d dicated above. : Á à ;
O orate press I Tne Seno MEICARGG ARGUE clockwise until the end and then turn the knob which goes off after a while.
anti-clockwise to the bar mark.
1- Turn the knob clockwise until the end. This timer is for timing any process and
does not cut the gas off.
11
12