BELARUS-920.4/952.4 Operating manual
8
End of Table 1
Parameter (characteristic) designation Value for tractor “BELARUS”
2) PTO shank speed with synchronous
drive, rev. per meter of travel
3,2
For tires
18.4R34
b) rear lift linkage:
1) lifting capacity of rear lift linkage
on suspension axle, at least kg
2) pump volume feed at rated engine
crankshaft speed, at least l/min
4000
45
3) hydraulic system pressure relief
cracking pressure, MPa
20
-2
4) conditional volume factor of hy-
draulic system (efficiency factor), at least
0,65
5) lifting time for rear lift linkage from
the lowermost position into uppermost
position with test load on the suspension
axle, s, at least
2,2
c) drawbar hitch:
1) virtual displacement of coupling
point, mm:
- in horizontal plane relative to tractor
longitudinal axis
- in vertical plane relative to ground
surface on the basic configuration tires,
mm:
2) distance between PTO end and tow-
ing yoke hole axis, mm
3) opening, mm:
- depth
- height
160 with intervals of 80±5
200 – 500
395±10
65±2
62±2
1)
To be specified depending on the configuration.
https://tractormanualz.com/
To Next Page
Loading...
