To Next Page

To Previous Page

COMPUTER FUnCTiOnS

Clock (12H/24H): A 12 or 24-hour digital clock is displayed on the

third row of the screen. After Km/mile selection in setup mode,

the 12h/24h will ash. Press the RIGHT button to switch between

the 12 and 24-hour format.

Press the LEFT button to conrm and advance to the clock mode.

Press the RIGHT button to advance the hours (hold RIGHT button

for fast advance). Press the LEFT button to conrm hours. Press

the RIGHT button to advance minutes (hold RIGHT button for fast

advance). Press LEFT button to conrm minutes and advance to

“Maintenance Required Function”.

Maintenance Required Function: On the top left hand side a

wrench icon will be displayed, just below the wrench the KM

(or miles — M) will be displayed and the top row digits will be

ashing. The digits represent the distance interval in KM (or miles)

that the wrench icon will start ashing to remind you to perform

maintenance on your bicycle. You can choose a maintenance

reminder for every 200, 400, 600 and 800 KM (or miles). If 600

KM is chosen, the wrench will ash every 600, 1200, 1800 KM (or

miles), etc. Press the LEFT button to stop the wrench ( ) from

ashing. Press LEFT button to conrm maintenance interval and

exit setup mode.

ODOMETER: To set the odometer

(ODO) after battery replacement

and wheel size setting, press RIGHT

button to advance to ODO mode

and then hold LEFT button for 5

seconds until the last digit of the

ODO is ashing. To adjust the value,

press the RIGHT button and then

press the LEFT button to conrm

and select the value. Repeat this

sequence to reach the desired

odometer value.

Bell Console 500 User Manual

Questions and Answers: