8
Before First Use
1. Carefully unpack the Rotating Wafe Maker and remove all packaging
and materials.
2. Before using your Wafe Maker for the rst time, wipe the cooking
plates with a damp cloth to remove all dust, and then dry. Wipe outer
surfaces with a slightly damp, soft cloth or sponge.
CAUTION: Take care to prevent water from running into the appliance.
Never immerse ROTATING Wafe Maker BODY in water or any other
liquids!
3. Set the appliance on a dry, clean and at surface. Keep the handle folded
until use.
Operating Instructions
1. Unfold handle and lift top cooking plate. Make sure the Rotating Wafe
Maker’s bottom cooking plate is positioned at and locked into a stable
position. Before baking the rst wafes of the day, use a pastry brush to
lightly coat the top and bottom wafe plates with vegetable oil. Do not
use non-stick sprays as they can cause build-up on the cooking plates.
2. Plug unit into a 120 V AC electrical outlet. The red POWER light will
illuminate and remain lighted during use.
NOTE: When your Rotating Wafe Maker is heated for the rst time, it
may emit slight smoke or odor. This is normal and should disappear
after one or two uses. This does not affect the safety of the appliance.
However, as it may affect the avor of the rst wafes prepared in the
Wafe Maker, it is recommended that these be discarded.
MIN
Keeps
wafes warm
MAX
Preheat
Wafe Maker
Red
POWER
Light
Blue
READY
Light
Top View
To Next Page
Loading...
Need help?
General
