Belling IH6013 - Page 5

USING THE HOB - INDUCTION
TOUCH CONTROLS
The touch controls for your induction hob
have been designed to provide you with
ngertipcontrolofyourhob,providing
accurate and repeatable power settings
for cooking and an easy clean surface
that can be easily wiped over. When a
cook zone is activated the power setting is
displayed for each zone individually.
Important Notice:-
Before switching on the power supply to
this appliance, switch off any bright lights
(such as cooker hood) and ensure the ap-
pliance is not in direct sunlight.
This is to enable the electronic controls
to calibrate its sensitivity against natural
ambient lighting (approx 30s).
Failure to observe the above will result
in the hob not functioning correctly, To
rectify remove all strong lighting sources
and re-apply power
The hob should complete the calibration
procedure satisfactorily and lighting such
as cooker hoods can be used normally.
Using the Touch Controls
Usetheatofyournger,notthetip,the
controls respond to touch, so you don’t
need to apply any pressure.
Always ensure the control area is clean,
dry and free from of any objects (e.g.
utensils, tea towels and cloths), spillages
andwatermaymakethecontrolsdifcult
to operate.
A warning will be activated and will beep
every 10 seconds, to attract your atten-
tion, please remove any objects and clean
the control area as appropriate.
Basic Control Functions
Key Lock
A RED LED indicates when the key lock is
active, to deactivate/activate touch the
Key Lock key for 1s.
The key lock is deactivated when the Red
LED switches off.
If the cook zones are on, the key lock
function locks all the keys except the
ON/OFF.
When all the hob cook zones are off,
the key lock function locks all the keys,
including the ON/OFF key.
The Key Lock is automatically activated
when the power is initially applied to the
hob.