Belling IH6013 - General Information

INSTALLATION
Suitable protection to prevent obstruction
of the air inlet to the fans must be
provided.
We recommend that you install this ap-
pliance in a work top which is a minimum
38mm deep.
Thehobcanbettedintoaworktop
less than 38mm deep, but the 20mm gap
between hob base and appliance must be
maintained.
General information
Installation should only be carried out by
aqualiedinstallerorengineer.
Please keep to the following points most-
carefully;
Although every care has been taken toen-
sure this appliance has no burrs, or sharp
edges, we recommend that you wear pro-
tective gloves when installing and moving
this appliance. This will prevent injury.
Thehobshouldnotbettedabovea
washing machine, a fridge or a freezer.
Wall surfaces above the work surface and
in the immediate vicinity of the cooking
hob must be heat resistant.
Laminated surfaces and the adhesive
usedforxingthemmustbeheatresis-
tant in order to avoid any damage.
The space for air circulation, located
underneath and at the back of the hob
improves its reliability by ensuring that it
willcooldown,efciently.
Installations should be carried out in line
with the National Regulations applicable
with this product type.
Choosing your installation
Make sure that the air inlets through the
ventilator grids underneath the hob are
never blocked.
Installing the hob over a unit with a
drawer or door
Air outlet is underneath work surface.
If necessary, remove the front crosspiece
of the unit.