Belling IH6013 - Troubleshooting

USING THE HOB
TROUBLESHOOTING
The hob produces a smell the rst
few times it is used
Heat a pan full of water on each zone for
half an hour.
Pans make a noise during cooking
This is caused by vibration due to the pas-
sage of energy from the hob to the pan.
On a high setting this is quite normal for
certain types of saucepan. It will not dam-
age the hob.
The hob makes a slight clicking
sound
This is caused by the distribution of power
between two heating zones on the same
side of the hob.
The fan keeps working for a few
minutes after the hob has been
turned off
To cool down the electronics.
Hob Status
Codes
Hob Status Description Action
r
Max power setting reached (only on
13Amp versions)
Reduce power setting on other zones, refer to user section.
U
Indicates no pan or suitable pan on
cook zone
Ensure correct pan size and that the pan is suitable for induc-
tion use (Check with a magnet)
H/C
Heater Over Temperature Product will
auto reset, Indicates pan overheat,
Allow hob to cool
C/P
Heater Over Temperature Product will
auto reset, Pan overheat
Allow hob to cool
H/c Induction Generator Over Temperature
Checkinstallationandfreeairowtohob
H Residual Heater
No Fault “ H” will switch off when glass surface drops below
55
o
C
The hob won’t work. The indicators
don’t come on
The electricity supply is not reaching the
appliance (faulty supply or connection);
Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if
problems persist call, the customer ser-
vice hot line for further assistance.