Beltronics BEL990 - Description of Features L; Power-Up Test Sequence;Start-Up Mode L


7. Laser Optical Sensors: collect Laser signals from in front
and behind.
8. Audio Alert Speaker: all audible alerts and Digital Voice
Messages are emitted from this location.
9. Power Jack: using the straight or coiled cord, the
bel 990 International operates in any vehicle with a 13.8 volt
dc negative ground system (10.5 volt to 16 volt range).
description of features
Power-Up Test Sequence/Start-up Mode
Each time your detector is turned on, bel 990 International
will perform a power-up test sequence based upon the start-up
mode selected. There are three start-up modes of operation
plus a Tutorial mode. Release the pwr button at your chosen
selection.
Note—Pressing pwr at any time during start-up test will bypass
the sequence.
NORMAL (Factory pre-set Mode)
Presents
START UP, followed by Audio and Text Messages for
Laser, Ka, K, X and Safety Warning System® (sws
™
) and the
Travel Mode selected (factory default is NAmerica). After this
sequence, the status of Selectable Features is displayed:
“
CTY X or CTYALL”; “X/K/KA BAND ON/OFF”;
“ AUTOMUTE, ON/OFF”;“VoiceON”,“V o i c e OFF”;
“KANARROW”,“KAS-WIDE”;“SWS o n ”,“SWS o f f ”;
“SWSv o i c e ”,“SWSc lic k ”; SCROLfa s t ”, SCROLslow”.
Unit is now ready for operation.
MODS (Modifications Mode)
Presents
START UP, followed by Travel Mode selected and
Selectable Features as chosen by the user. Unit is ready for
operation.