Beltronics RX 65 - Device Ports and Indicators; Power Connector and SmartPlug

'(ontrols'.and'.··.Feafures
Power Connector
RX65's power jack uses a telephone-type
connector. This new 6-pin connector only
works with the included coiled SmartPlug,
or the optional Direct-wire SmartPlug.
The coiled SmartPlug is a special power
cord that has a power-on indicator (which
only lights up when the RX65 is turned on),
a bright alert light that warns of radar or
laser, and a convenient mute button right
on the plug. It's perfect for any car where
reaching the detector's mute button on the
windshield is a stretch.
For discreet night driving, put RX65 in
the Dark mode, and use the SmartPlug for
your visual alerts. Other drivers won't know
you have a detector.
An optional Direct-wire SmartPlug is
also available. This version includes a small
display module, which can be wired
directly into your electrical system, with a
10 foot straight
cord to route to your RX65.
For
more information or to order, call
us toll-free at 1-800-341-2288.
10
Signal Strength Meter
RX65's alphanumeric display consists of
280 individual LEDs, to provide an intuitive
ultra-bright display
of signal strength and
text messages.
RX65's standard bar-graph signal
strength meter only displays information on
a single radar signal. If there are multiple
signals present, RX65's internal computer
determines which is the most important
threat to show on the bar-graph meter.
When RX65 detects radar, it displays
the band ex, K, or Ka), and a precise bar
graph of the signal strength. When RX65
detects a laser signal, the displaywill show
"Laser."
NOTE:
If you are operating RX65 in the
Dark mode, the display will not light when
a signal is detected - only the audio alert
will be heard, and the flashing alert lamp on
the SmartPlug.