Power
Connection
To
power
RX65, plug
the
small
end
of
the
SmartPlug, (telephone-type connector) into
the
modular jack
on
RX65
's right side,
and
plug
the
lighterplug adapter into your
vehicle's lighter socket
or
accessory socket.
RX65
operates
on
12 volts DC negative
ground only.
The
lighter plug provided is a
standard size
and
will
work
in most
vehicles. However, some vehicles may
require
the
optional European sleeve
to
ensure a snug
fit.
If
so, simply call
our
service department
to
order
one. This
sleeve slides over
the
SmartPlug's lighter
plug adapter.
Of
course, your lighter socket
must
be
clean
and
properly
connected
for
proper
operation.
Note: depending
on
yourvehicle,
the
lighter socket
power
mayeither
be
continuously on,
or
it may
be
switched
on
and
off
with
your ignition switch.
optional
power
cords
See
the
Accessories section for details
on
our
optional Direct-wire SmartPlug.
6
Mounting
Location
WARNING:
BELlRONICS cannot anticipate
the
many ways
the
RX65
can
be
mounted.
It is important that you
mount
RX65
where
it will
not
impair yourview
nor
present a
hazard in case
of
an
accident.
Where
to
mount
RX65
For optimum detection performance,
we
recommend
the
following:
• Using
the
Windshield QuickMount,
mount
your
RX65
level, and high enough
on
your
front windshield
to
provide a clearview
of
the
road from
the
front andrear.
• Mount
RX65
away from windshield
wipers,
other
solid objects, and heavily
tinted areas that might obstruct the radar
antenna
or
laser lens.
To Next Page
Loading...
