15
3. Adjust the rip guide shoe to the correct distance from the blade and tighten the
rip guide adjusting knob.
LIVE WIRE INDICATOR
The live wire indicator (1) will turn ON when the plug is inserted into a "live" 110V
receptacle (Fig. 8). If the live wire indicator fails to turn on, this indicates the plug is
not inserted into a "live" receptacle.
LED WORK-LIGHT
The LED work-light (1) will turn ON automatically when the tool is plugged into the
power supply (Fig. 9). It will turn OFF when the plug is removed from the power
supply.
1 1
FIG. 8 FIG. 9
WARNING: For safety reasons, the operator must read the sections of this
Owner’s Manual entitled “GENERAL SAFETY WARNINGS“, “POWER TOOL
SAFETY“, “SPECIFIC SAFETY RULES“, “EXTENSION CORD SAFETY“ and
“SYMBOLS” before using this circular saw.
Verify the following every time the circular saw is used:
1. The blade is tight and sharp.
2. All adjustments are tight.
3. The workpiece is properly secured.
4. Safety glasses and hearing protection are being worn.
Failure to adhere to these safety rules can greatly increase the chances of
serious injury.
To Next Page
Loading...
