19
It has been found that electric tools are subjected to accelerated wear and
possible premature failure when they are used on fiberglass boats and sports
cars, wallboard, spackling compounds or plaster. The chips and grindings from
these materials are highly abrasive to electric tool parts such as bearings, brushes,
commutators, etc. Consequently, it is not recommended that this tool be used
for extended work on any fiberglass material, wallboard, spackling compounds or
plaster. During any use on these materials it is extremely important that the tool is
cleaned frequently by blowing it out with an air jet.
WARNING: Always wear safety goggles or safety glasses with side shields
during all cutting operations. It is critical that you also wear safety goggles or
safety glasses with dust out of the circular saw with an air jet. Failure to take
these safety precautions could result in permanent eye or lung damage.
If the motor brushes require replacement, contact the toll-free customer support
line: 1-866-349-8665 Monday – Friday from 9am to 5pm Eastern Standard Time
LUBRICATION
lubricant for the life of the unit under normal operating conditions. Therefore, no
further lubrication is required.
EXPLODED VIEW
To Next Page
Loading...
