12
TM
4. PRE-OPERATION CHECK
These quick checks should be done each time the pressure washer is started to
ensure you get the most out of your pressure washer.
Set the pressure washer on a level surface and the power switch to OFF.
WARNING!
Exhaust gas contains poisonous carbon monoxide. Never run
the pressure washer in an enclosed area. Be sure to provide
adequate ventilation. Operate the pressure washer on a level
surface. If the pressure washer is tilted, fuel spillage may result.
Keep away from rotating parts while the pressure washer is
running. The pressure washer is air-cooled and may be damaged
if ventilation is inadequate.
4.1 CHECK PUMP OIL LEVEL
1. Ensure the pressure washer is on a level surface.
2. Unscrew one of the two oil dipsticks and clean the dipstick.
3. Check the oil level by reinserting the oil dipstick without screwing it back in.
Remove the dipstick and examine the oil level. If the level is at or below
the minimum oil level marked on the dipstick, rell to the maximum oil level
mark.
4. Reinsert the dipstick and tighten securely.
To Next Page
Loading...
Need help?
General
