22
TM
6. USING YOUR PRESSURE WASHER
DANGER!
NEVER direct the water flow at people. The high pressure
jet can be dangerous if misused and must not be directed at
people, animals, electrical devices or the unit itself. DO NOT
TREAT FLUID INJECTION AS A SIMPLE CUT! Seek medical help
immediately.
WARNING!
Do not run the pump without connecting to the water supply and
turning the water on. Failure to do so could damage the pressure
washer. Failure to follow these instructions will void product
warranty.
Water that passes through this unit is not safe to drink.
NOTE
DO NOT allow the unit to run for more than 2 minutes without pulling
the trigger to release water pressure. This could cause overheating and
damage to the pump. When the temperature inside the pump gets too
high the thermal relief valve will temporarily open and release a spray of
water from the pump to lower the internal temperature.
6.1. USING THE SPRAY WAND
1. Flip the safety up.
2. Pull back on the trigger to begin emitting water.
3. To stop water ow, release the trigger.
To Next Page
Loading...
Need help?
General
